Traverse DeskGet COGO
Direction and distance

Reduce a slope distance before checking a horizontal traverse

A 65 m slope measurement and 16 m height difference give a 63 m horizontal course. Use it to diagnose a two-metre loop error.

Worked example√(65² − 16²) = 63 m horizontal
On this pageIdentify the endpoints of the measurementCheck which angle convention is in useTest the reduction on a loopPreserve the measurement chain

A diagonal tape measurement of 65 m joins points 16 m apart in elevation. Enter the entire tape length as a horizontal course and the plotted endpoint lands two metres too far away. The three measurements in this calculation describe different sides of the same vertical triangle.

Identify the endpoints of the measurement

For the worked example, the slope distance and vertical difference refer to exactly the same endpoints. The slope distance is the hypotenuse. The vertical difference forms one leg and the horizontal distance forms the other. Square the slope length, subtract the squared vertical difference and take the square root. Here √(65² − 16²) = √3969 = 63 m.

A difference between ground elevations is not automatically the same as the vertical separation between an instrument axis and a prism center. If the observed slope distance runs from one of those elevated points to the other, the heights used in the reduction must be consistent. Confirm which quantities your instrument export has already reduced before applying a second correction.

Quantity Example Role
Slope distance 65.000 m Measured along the inclined line
Vertical difference +16.000 m Upward separation of its endpoints
Horizontal distance 63.000 m Plan displacement along the bearing

The sign of the rise matters for elevations. Squaring that difference removes its sign in the horizontal-distance calculation. A 16 m descent over the same slope length also produces 63 m of horizontal travel.

Check which angle convention is in use

An elevation angle is measured from horizontal. The horizontal component equals slope distance times the cosine of that angle. A zenith angle is measured down from the upward vertical. For that convention use slope distance times the sine of the zenith angle. The two angles are complementary for an upward sight.

Check the instrument convention with a level line. An elevation angle of zero must produce the entire slope distance as horizontal. A zenith angle of 90° must do the same. Using a zenith angle where an elevation angle was expected swaps horizontal and vertical components. In this particular example that would turn a 63 m plan side into a 16 m side.

Test the reduction on a loop

Start a rectangular demonstration with azimuths 0°, 90°, 180° and 270°. The horizontal lengths are 63, 24, 63 and 24 m. Paste those pairs into the closure calculator to get a zero gap and 174 m of travel. Change only the first length to 65.000 m. The return now lies two metres north of the start and the total travel becomes 176 m. The correction belongs in the first observed side’s reduction, assuming the original records confirm the measurement type.

If both north and south sides were accidentally entered as 65 m, the loop would close again. Its dimensions and computed area would still be wrong. Rechecking the independent diagonal or comparing an original horizontal distance with the inverse between known endpoints supplies a check the closed circuit alone cannot provide.

Preserve the measurement chain

Keep columns for the original slope measurement, the associated zenith or elevation angle or vertical difference, the resulting horizontal distance and any subsequent grid reduction. Record whether the units are metres or feet at each stage. A component greater than the original slope distance signals an impossible reduction and deserves a review of units, geometry and signs.

When only a rounded elevation difference is available, report the precision it supports. A steep line is particularly sensitive because a small change in vertical separation can change the horizontal component noticeably. For a production job, use the approved instrument reductions and observation records. This short example gives an independent arithmetic check on their scale and direction.

References

Check traverses offline with COGO